Cable ties, holders and spiral wraps

Cable ties, holders and spirals are different ways to organise cables. Clarify whether you need to tighten a bundle, attach it to a surface or wrap it along its length before comparing sizes.

Separate the organisational tasks

Product titles include cable ties, tie mounts and spiral cable wraps. Make a separate selection for each element required. For a tie, check the appropriate length and width for the bundle and application. For a mount, clarify the fixing method and compatibility with the chosen tie. For a spiral wrap, compare the size with the cables it will enclose. These are different checks, so do not transfer designations from one type of accessory to another.

Conditions of use are also a criterion

Catalogue names contain different colours and material designations. For the chosen reference, check applicable environmental conditions, mounting method and limitations. Do not assume colour alone certifies sunlight resistance or that a general name determines permissible load. Match specific project requirements to the product documentation. For points on a substrate, also check required fasteners instead of assuming they are included.

Allow for cable changes

Clarify whether the bundle will be extended and the service access required. During selection, check whether the specific element is intended for the working method planned. Record holder locations and quantities required by section. Do not use a tie as a substitute for the complete cable routing and support system. When such a solution is required, explore cable trays and fixings or cable trunking and accessories.

Compare the product and packaging

Check whether the stated quantity is for an individual connector, set or pack. To compare the variants shown by manufacturer, you can browse BM and LEGRAND, retaining the size and application requirements. If the list also includes protective cable routing, continue to cable conduits. The general cable routing and installation section helps combine the accessories with the other project parts without confusing their purposes.